L Rod Rack Clamp

I made some L-Rod clamps from a block oak wood, I have also made them out off plastic 2×4 lumber and the plastic works even better.

Wood Block for rack clamp
2-7/8″ x 1-3/8″ x 4″ block of oak wood painted black.

Oak wood block
Drilled a 1-1/4″ hole through the block and a 7/8″ hole 1-3/4″ deep for the L-rod.

rack clamp
Drilled 11/32″ for the threaded insert and 19/64″ hole for the t-nut.

(Check the package for correct hole size for threaded inserts and t-nuts they may be different for different brands.)

Can find them here.
Threaded Insert 1/4-20
1/4-20 T-Nuts

Rack Clamp
Arrow show where I cut a slot with double bladed hacksaw. Used vice to press the knobs on the 1/4″ socket cap screws.

Socket Head Cap Screw Part # 91251A542 and Knobs Part # 94052A141 http://www.mcmaster.com

Or purchase here:
Socket head cap screws
Knobs

Rack clamp
Rack Clamp
Diy L rod
The L-Rods can be expensive and hard to find. You can also make your own L Rods using .79 cent anchor bolts .
I have also made the clamps using plastic 2 x 4 lumber. They are easy to make. The images are self explanatory. Knobs can also be pressed on to the socket cap screws.

You can use them with the  7/8 L-Rods or the cymbal arms.
 
Make your own L-Rods. Make the hole a little smaller then the thread size for the home made L-Rod. These bolts are about 10″ long and will fit a 1/2″ hole. I was able to bend them using a bench vice and a 3′ pipe.
 

There are links in the tutorial to where you can find most of the parts I used in this project. Here are some of the parts and tools I used on all the different projects. Parts List   Tools