8 INCH WOOD DRUM HOOP

 

hoops

I was able to make enough bottoms and top hoops using 4’x2′ and 2’x2′ oak veneer press board.


hoop2

Here is a close up image. I broke into it so you could see the inside. Hopefully this will give a clue to what I’m using. It seems to be very strong and heavy.  I have tried to use pine in the past without success. The pine would split when tightening down the hoops. Real oak wood is very expensive. The wood I’m using here feels as heavy as real oak wood.


hoop3

I drilled a 1/8″ hole for the pin. I wanted to get as close to the edgeas possible and utilize as much wood as possible. I used a circle jig that I purchased here. Router circle jig You also need to use a 1/4″ cutting bit.


hoop4

I used the 10 1/16″ circle jig hole to cut the outside diameter. Increase the depth of the cut a little at a time. I made about 3 passes.


hoop5

I screwed down the circle to keep it in place while I make the remainder of the cuts. I set the router to cut a depth of about 1/2″ I will now be cutting the groove for the mesh head.


 

hoop6

I used the 8 9/16″ circle jig hole to start cutting the 1/2″ deep groove. I made one pass with the router. After every pass I decreasedthemeasurement of the circle jig 1/8″ until I reached the 8 1/16″ circle jig hole. At the 8 1/16″ circle jig hole setting I finished cutting down through the wood making a few more passes increasing the depth a little at a time.


hoop7

That’s all there is to it. Now you have a 8″ wood hoop.

The outside diameter for the bottoms is the same as the top. I used the 10 1/16″ circle jig hole to cut the bottoms. I used the 7 13/16″ circle jig hole to cut the 1/4″ deep groove for the plastic bucket piece to sit down into.

Note: Because I used the leftover circle from the 10″ hoop, this hoop would be slightly smaller than a regular 8″ hoop, so a regular 8″ drum head will not fit and you would need to use a DIY drum head.


 DIY ELECTRONIC DRUM TUTORIALS

Build Electronic Drums – My first project

Build Electronic Drums Using Drum Shells

Acoustic Drums to Electronic Drums

Acoustic Bass Drum to Electronic

Build an Electronic Drum Kit with Buckets

Bucket Bass Drum

Rock Band Drum kit 8″ Mesh Drum Head Mod

Rock Band Drum Kit – My First RB Drum Set


BUILDING DRUM ACCESSORIES

10 inch Wood Drum Hoop

8 inch Wood Drum Hoop

Electronic Drum Mount

DIY Window Screen Mesh Drum Heads

Turn Sanding Blocks into Foam Cones

L Rod Clamps

Back to Top